How to make “ 2Pin Peg Bar” for Animation

This is the easiest method compared to the existing ones. The 2 Pin Peg Bar
can be made with simple Office material.

Step One:
Cut 2 pieces (pins) each ½ an inch wide from used Ball pen refill.

Step Two:
Roll pin with ½ inch wide Cello tape sufficient enough to match diameter
with punch hole.

Step Three:
Paste punched paper strip on the (6 inch plastic) foot scale to mark
position for the pins.

Step Four:
Fix pins on the scale with adhesive glue. (Rub lower tip of pin on rough
surface to stick better). Allow to dry for a few minutes before use.

Make extra Peg Bars and keep ready incase of a necessity.